FrameBuilder-MRD Homepage
Forum Home Forum Home > FrameBuilder MRD > DIY Advice
  New Posts New Posts
  FAQ FAQ  Forum Search   Register Register  Login Login

How to Build a Light Steel Structure Part 2

 Post Reply Post Reply
Author
Message
BSRSA View Drop Down
Newbie
Newbie
Avatar

Joined: 23 Jan 2019
Points: 13
Post Options Post Options   Thanks (0) Thanks(0)   Quote BSRSA Quote  Post ReplyReply Direct Link To This Post Topic: How to Build a Light Steel Structure Part 2
    Posted: 24 Jan 2019 at 9:28am

Materials, Shapes, and Standard Sizes

 

 

Cold-Formed Steel

 

Material

 

Structural and non-structural framing members utilized in steel construction shall be cold-formed to chape from sheet steel complying with the requirements of ASTM A1003/A1003M [23].

 

 

 

Corrosion Protection

 

Structural and non-structural framing members utilized in steel construction shall have a minimum metallic coating complying with the requirements of ASTM A1003/ A1003M [23]. Unless additional corrosion protection is provided, framing members shall be located within the building envelope and adequately shielded from direct contact with moisture from the ground or the outdoor climate. Dissimilar metals shall not be used in direct contact with steel framing members. Steel framing members shall not be embedded in concrete, unless approved for that purpose.

 

Fasteners shall have rust inhibitive coating suitable for the installation in which they are being used, or be manufactured from material not susceptible to corrosion.

 

 

 

Member Designation

 

The standard designator defined in this section is used to identify framing members used in cold-formed steel construction. The designator consists of the following sequential codes:

 

A three or four-digit numerical indicating member web depth in 1/1000 inch. A letter indicating:

 

S = Stud or joist framing member which have lips

T = Track section

U = Channel or stud framing section which do not have lips

F = Furring channels

L = Angle or L-header

 

A three-digit numerical indicating flange width in 1/100 inch, followed by a dash. A

two or three-digit numerical indicating base metal thickness in 1/1000 inch (mils).

 

Example: Designation for a 5 1/2"-16 gauge C-shape with 1 5/8" flanges:

550S162-54

 

Back to Top
hyeetech View Drop Down
Newbie
Newbie
Avatar

Joined: 20 Jul 2020
Location: Pakistan
Points: 1
Post Options Post Options   Thanks (0) Thanks(0)   Quote hyeetech Quote  Post ReplyReply Direct Link To This Post Posted: 20 Jul 2020 at 7:53pm
need software of steel framing
ghtro
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.188 seconds.